October 6, 2014

Keurig 2.0 Hack

So you got the new Keurig 2.0 (against my advice) and you have gotten the dreaded "Oops" message. You have either tried to use a Keurig K-cup that is a few months old or a generic cup that used to always work in your Keurig brewer. I am here to help you and provide you with a very easy Keurig 2.0 Hack. You're welcome. 


You will need a new Keurig brand K-cup that has the rim of white around the edge and some type of cutting tool. I couldn't find a box cutter so I used a kitchen knife. Don't judge me. 


Cut just the label off the K-cup. I used a brew-your-own generic cup to put the coffee from the new k-cup - no waste! 


Tape the new k-cup label to the top of your Keurig 2.0 so the needle goes through the center of the label. This may take some trial and error to get it perfect. 


I used basic tape and made sure it was held very well to hold up through multiple uses. The 2.0 "reads" the label so as long as the label is where the machine can read it, it will work! 


I have been able to brew multiple cups of any type using this hack. It will take a little more push to close the top, but as long as you're careful the label will stay on. 

This hack also let's you get hot water without holding the brew button down. Don't put a KCup in the machine and you can change the ounces just like you would when you brew but just get hot water!


Brew away!! 

If you like this hack, make sure to share it with your friends! And if you have any questions please message me! 

No comments:

Post a Comment

Leaving comments brings good luck!! Plus I really like them.

Are You a No-Reply Blogger? Click HERE to find out!

Related Posts Plugin for WordPress, Blogger...